4.
Lower the forks or other implements to the ground
before performing any work on the truck. If this
cannot be done, make sure the forks or other
implements are blocked correctly to prevent them
from dropping unexpectedly.
5.
Use steps and grab handles (if applicable) when
mounting or dismounting a truck. Clean any mud
or debris from steps, walkways or work platforms
before using. Always face truck when using
steps, ladders and walkways. When it is not
possible to use the designed access system,
provide ladders, scaffolds, or work platforms to
perform safe repair operations.
6.
To avoid back injury, use a hoist when lifting
components which weigh 23 kg (50 lb.) or more.
Make sure all chains, hooks, slings, etc., are in
good condition and are of the correct capacity. Be
sure hooks are positioned correctly. Lifting eyes
are not to be side loaded during a lifting
operation.
7.
To avoid burns, be alert for hot parts on trucks
which have just been stopped and hot fluids in
lines, tubes and compartments.
8.
Be careful when removing cover plates.
Gradually back off the last two bolts or nuts
located at opposite ends of the cover or device and
pry cover loose to relieve any spring or other
pressure, before removing the last two bolts or
nuts completely.
9.
Be careful when removing filler caps, breathers
and plugs on the truck. Hold a rag over the cap or
plug to prevent being sprayed or splashed by
liquids under pressure. The danger is even greater
if the truck has just been stopped because fluids
can be hot.
The serviceman or mechanic may be unfamiliar with
many of the systems on this truck. This makes it
important to use caution when performing service
work. A knowledge of the system and/or components
is important before the removal or disassembly of any
component.
Because of the size of some of the truck components,
the serviceman or mechanic should check the weights
noted in this Manual. Use proper lifting procedures
when removing any components.
Following is a list of basic precautions that should
always be observed.
1.
Read and understand all warning plates and decals
on the truck before operating, lubricating or
repairing the product.
2.
Always wear protective glasses and protective
shoes when working around trucks. In particular,
wear protective glasses when pounding on any
part of the truck or its attachments with a hammer
or sledge. Use welders gloves, hood/goggles,
apron and other protective clothing appropriate to
the welding job being performed. Do not wear
loose-fitting or torn clothing. Remove all rings
from fingers when working on machinery.
3.
Do not work on any truck that is supported only
by lift jacks or a hoist. Always use blocks or jack
stands to support the truck before performing any
disassembly.
SAFETY
The proper and safe lubrication and maintenance
f o r t h e s e f o r k l i ft t r u c k s , r e c o m m e n d e d b y
Mitsubishi Forklift Trucks, are outlined in the
OPERATION & MAINTENANCE MANUAL.
Improper performance of lubrication or
maintenance procedures is dangerous and could
result in injury or death. Read and understand the
OPERATION & MAINTENANCE MANUAL before
performing any lubrication or maintenance on
these trucks.
Do not operate these trucks unless you have
read and understood the instructions in the
O P E R AT I O N & M A I N T E N A N C E M A N U A L .
Improper truck operation is dangerous and could
result in injury or death.
WARNING
!
WARNING
!
WARNING
!
