Mitsubishi 4G1 series, Руководство по обслуживанию

Страница: 201 / 522

ENGINE
Cylinder Head and Valves SOHC
0.5 1 mm
mm
in.)
1
1
Removal Installation
Press
Press
a
a
Push rod
-01
Valve
guide Valve
guide
VALVE SEAT RECONDITIONING PROCEDURE
Before correcting the valve seat, check for clearance
between the valve guide and valve and, if necessary,
replace the valve guide.
(2) Using the special tool or seat grinder, correct to obtain the
specified seat width and angle.
(3) After correction, valve and valve seat should be lapped with
a lapping compound.
VALVE SEAT REPLACEMENT PROCEDURE
Cut the valve seat to be replaced from the inside to thin the
wall thickness. Then, remove the valve seat.
(2) Rebore the valve seat hole in the cylinder head to a selected
oversize valve seat diameter.
Seat ring hole diameter: See “Service Specifications”
on page
(3) Before fitting ttie valve seat, either heat the cylinder head
up to approximately or cool the valve seat in
liquid nitrogen, to prevent the cylinder head bore from
galling.
(4) Using a valve seat cutter, correct the valve seat to the
specified width and angle.
See “VALVE SEAT RECONDITIONING PROCEDURE”.
VALVE GUIDE REPLACEMENT PROCEDURE
(1) Using the special tool and a press, remove the valve guide
toward cylinder head gasket surface.
(2) Rebore valve guide hole to the new oversize valve guide
outside diameter.
Valve guide hole diameter: See “Service Specifica-
tions” on page
NOTE
Do not install a valve guide of the same size again.
(3) Using the special tool, press-fit the valve guide, working
from the cylinder head top surface.
(4) After installing valve guides, insert new valves in them to
check for sliding condition.
(5) When valve guides have been replaced, check for valve
contact
and correct valve seats as necessary.
TSB Revision