EN-8
Remote control
Battery installation
Use two (AA, R6) size batteries.
1.
Remove the back cover of the remote control by pushing the battery compartment door in the direction of the arrow.
2.
Load the batteries making sure that they are positioned correctly (+ to +, and - to -).
•
Load the batteries from - spring side, and make sure to set them tightly.
3.
Replace the back cover.
Caution:
•
Use of a battery of wrong type may cause explosion.
•
Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
•
Dispose of used batteries according to your local regulations.
•
Batteries may explode if misused. Do not recharge, disassemble, or dispose of in fire.
•
Be sure to handle the battery according to the instructions.
•
Load the battery with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.
•
Keep batteries out of reach of children and pets.
•
Remove the battery, if the remote control is not used for a long time.
•
Do not combine a new battery with an old one.
•
If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them
with water and then consult your doctor.
Operation range (of the remote control)
The maximum operation distance of the remote control is about 10 m (or about 32 feet) when the remote control is pointed at the remote control
sensor of the projector. When the remote control is pointed to the screen, the distance from the remote control to the projector via the screen should
be 5 m or less. However, the operation distance varies depending on the type of the screen used.
Reception angle (vertical)
Important:
•
Do not expose the remote control sensor to direct sunlight or fluorescent. Keep a distance at least 2 m (6.5 feet) between the remote control
sensor and the fluorescent light to ensure correct operation of the remote control.
Inverted fluorescent light, if located near the projector, may interfere the remote control.
•
When you use the remote control too close to the remote control sensor, the remote control may not work correctly.
Reception angle (horizontal)
Reception angle (vertical), ceiling mount
