#1
- Remove the screws on Right and Left Side
(3 screws) from the top cover. Slip bracket between
the top and side of chassis; reinstall the cover and
re-fasten with screws that were taken out.
#2
- Install gables on the left and
right side, to the top mounting
bracket with screws provided (2 pcs).
#3
- Install the
Side Face Panel
with screws
provided
NOTE:
Wind Blockers are used to prevent direct wind exposure to the heat exchanger.
Windscreens are needed for the operation where the ambient temperature falls below -5° Celsius.
#6
-If required secure side blocker(s)
to the side of the wind screen where there
is direct exposure to wind. Use predrilled
holes and 4 pcs screws provided
to secure blocker to the wind screen.
Top Mtg Bracket
**CAUTION**
**CAUTION**
#4
- Secure Safety Cables to the
Cabinet chassis with existing
cabinet screws (as shown) and
tighten up the 2 screws already
installed on the Front Face Panel
#5 - On bottom secure
the gable by drilling
chassis with stubby
(short) 1/8" drill.
Take extra precaution
not to drill coil. Use 2 pcs of screws supplied
INSTALLATION PROCEDURE
PSD-12-18_201702
PSD-12-18 (SIDE WINDSCREEN)
