6. How to operate : In case of using LCD remote controller.
5
If you use the LCD remote controller, you can operate below method.
Please consult operate method with dealer, if you use field supply control parts.
For purposes of explanation, all the displays on this page are shown
in their lit condition. This configuration does not occur in the actual
unit.
Operation mode
Displays the status of operation.
[Checking] Display
This displays indication when some abnormality occurs in the unit.
[Current/start/ending time] Display
[Set temperature] Display
Displays the set temperature.
[Operation] Lamp
Lights up during operation, goes off during stop.
[Fan] Display
This displays indication fan operation.
[Key lock] Display
This display indication during key lock function active.
[Room temperature] Display
Displays the temperature of the air sucked in during operation.
Display section
* Make sure that the power supply is turned ON before use.
(Keep the power supply turned ON at all times when the air conditioner
is in use. Use of the unit without power can result in compressor failure.)
Check and confirm the power circuit before use. For the contents, refer to
the previously described chapter [Crucial points to be observed for safety].
Before starting operation
6.1 ON / OFF
Start operation
Press the [ON/OFF] button
Operation lamp lights up and operation starts.
Stop operation
Press the [ON/OFF] button again
Operation lamp goes off and operation stops.
* Once the buttons have been set, pressing of the [ON/OFF] button
only can repeat the same operation thereafter.
* During operation, the operation lamp above the [ON/OFF] button
lights up.
Operation lamp
A
B
C
D
E
F
G
H
[Timer Hold / Resume setting] Display
J
E
1
1
B
C
A
H
G
D
E
F
1
E
Warning:
Caution:
Even if the operation button is pressed immediately after the operation
is once stopped, operation is not restarted for about 3 minutes.
This function protects the machine. It automatically starts operation
after the lapse of approximately 3 minutes.
J
