P C L 5 1 0 0 f e a t u r e s a n d u p g r a d e s
PCL5100 USER GUIDE 13
18. Reconnect the fan-sink’s power cable to the motherboard. It
goes on the connector labelled
FAN 2
or
PL200
as shown on
the motherboard diagram.
CAUTION
If the fan-sink power cable is not reconnected properly the processor may
overheat and be permanently damaged.
19. Adjust the processor voltage and bus speed selection jumpers
in block
PL19
as described at the start of this chapter.
When you have finished, replace any expansion cards you needed to
remove, then refit the system covers.
Replacing the configuration battery
The computer keeps a record of its current hardware configuration
in a CMOS memory chip which is sustained by a small battery.
This battery has a life of up to 5 years. If you find that you have to
reconfigure the computer every time you turn it on, the battery is
probably failing and needs to be replaced.
The battery is a 3 volt lithium type (CR2032 or equivalent)
typically used in calculators and other small, battery-powered
electronic items.
