Mitsubishi Electric PEA-RP200WKA, Инструкции по эксплуатации

Страница: 5 / 12

5
①
②
③
■
Wireless Remote-Controller (option)
2. Parts Names
■
When using the wireless remote controller, point it towards the receiver on the indoor unit.
■
If the remote controller is operated within approximately two minutes after power is
supplied to the indoor unit, the indoor unit may beep twice as the unit is performing the
initial automatic check.
■
The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such
as fluorescent lights and strong light can affect the ability of the indoor unit to receive
signals.
■
If the operation lamp near the receiver on the indoor unit is flashing, the unit needs to be
inspected. Consult your dealer for service.
■
Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location
with high humidity.
■
To avoid misplacing the remote controller, install the holder included with the remote
controller on a wall and be sure to always place the remote controller in the holder after
use.
Battery installation/replacement
1. Remove the top cover, insert two AAA
batteries, and then install the top cover.
Top cover Two AAA batteries
Insert the negative
(–) end of each
battery first. Install the
batteries in the correct
directions (+, –)!
2. Press the Reset button.
CLOCK
CHECK
RESET SET
TEST RUN
MODE
FAN
VANE
LOUVER
min
h
AUTO START
AUTO STOP
ON/OFF
TEMP
NOT AVAILABLE
MODEL SELECT
TEST RUN CHECK
ON/OFF button
Pushing button starts operation.
Pushing again stops operation.
MODE SELECT button
This button is used to change
between auto, cooling, heating
and drying operation modes.
SET TEMPERATURE button
SET TEMPERATURE button
sets and any desired room
temperature.
AUTO STOP/AUTO START button
Used for selecting timed starting
or stopping.
h button
Used for setting the current time.
VANE CONTROL button
Used to change the airflow
direction.
FAN SPEED button
This button is used to set fan
speed to low, medium or high.
CHECK button
TEST RUN button
min button
Used for setting the current time.
LOUVER button
Used for adjusting the airflow
direction.
Press the Reset
button with an object
that has a narrow end.