Mitsubishi Electric PD-6130, Руководство по обслуживанию

Страница: 3 / 62

2-1
SAFETY SERVICE
■
Safety cautions
The matters to be observed without fail are explained below. These matters are indispensable for the prevention
of an accident during the maintenance servicing, the “security of products” after the completion of servicing
work, and the “prevention of the repeated occurrence of similar fault.”
(1) The degree of danger and material damage, caused as a result of wrong use by disregarding the contents
of the display” is distinguished and explained in the table below.
If this display is disregarded and equipment is handled wrongly,
this can be a cause of physical injury and a fire, thus leading a
person to death or serious injury.
If this display is disregarded and equipment is handled wrongly,
this may lead to personal injury or material damage.
(2) Kinds of the matters to be observed are classified and explained in the icons shown below.
This icon indicates a dangerous place where an electric shock is anticipated.
This icon indicates the contents of “caution” that must be borne in mind, without fail.
This icon indicates the contents of “caution” that must be practiced, without fail.
WARNING
CAUTION
WARNING
• Observe the caution matter, without fail.
• In the place where a particular caution is needed during maintenance servicing, such a
caution note is displayed with a label or a stamp that is given to the cabinet, chassis, PWB,
etc. These caution notes and also the caution matters of
WARNING
given in the
instruction manuals, etc., must be observed, without fail.
• Be careful of an electric shock or a burn.
• The power block or the PDP module involves the sections where high voltage or high tem-
perature is prevalent. When equipment is energized, use working gloves in order to prevent
an electric shock or a burn. At the time of transportation, disassembly, reassembly, and the
replacement of parts, such a servicing job must be done after pulling out the power plug.
• Modification of equipment is absolutely prohibited. Use the specified parts at all times.
• If any modification is performed, the validity of the manufacturer’s warranty is lost at that
moment. The personnel who did this modification is responsible for the physical injury or
the like, if it should occur as a result of the modification. The parts used are given the
safety-based characteristics, such as non-flammability or sufficient withstand voltage. The
parts to be replaced shall be those which are specified in the list of replacement
parts.(Example: The lithium battery (circuit symbol BA9501 in the MAIN PWB) will give
rise to explosion if its polarity is wrongly treated.
• The replaced parts and wiring must be arranged in the original conditions.
• For safety reasons, insulation materials like tubes and tapes may be used or some parts
may be mounted clear of the PWB. The internal wiring and the fastening with the clampers
for separation from high-heat and high-voltage parts shall be returned to their original
conditions, without fail.