Mitsubishi Electric MXZ-8B140VA, Техническое и сервисное руководство

Страница: 62 / 531

62
13 DISASSEMBLY PROCEDURE
OPERATING PROCEDURE PHOTOS & ILLUSTRATION
1. Removing the service panel and top panel
(1) Remove 3 service panel fixing screws (5 × 12) and slide
the hook on the right downward to remove the service
panel.
(2) Remove screws (3 for front, 3 for rear/5 × 12) of the top
panel and remove it.
2. Removing the fan motor (MF1, MF2)
(1) Remove the service panel. (See Photo 1.)
(2) Remove the top panel. (See Photo 1.)
(3) Remove 5 fan grille fixing screws (5 × 12) to detach the fan
grille. (See Photo 1.)
(4) Remove a nut (for right handed screw of M6) to detach the
propeller. (See Photo 2.)
(5) Disconnect the connectors, CNF1 and CNF2 on controller
circuit board in electrical parts box.
(6) Remove 4 fan motor fixing screws (5 × 25) to detach the
fan motor. (See Photo 3.)
3. Removing the electrical parts box
(1) Remove the service panel. (See Photo 1.)
(2) Remove the top panel. (See Photo 1.)
(3) Disconnect the indoor/outdoor connecting wire from termi-
nal block.
(4) Remove all the following connectors from controller circuit board;
fan motor, thermistor <Outdoor pipe>, thermistor <Compressor>,
thermistor <Outdoor 2-phase pipe>, thermistor <Outdoor>,
high pressure switch, high pressure sensor, low pressure switch,
solenoid valve coil <4-way valve> and solenoid valve coil
<Hot gas bypass>, solenoid valve coil <Returning oil bypass>.
Then remove a screw (4 × 8) from the valve bed to remove
the lead wire.
Pull out the disconnected wire from the electrical parts box.
<Diagram symbol in the connector housing>
• Fan motor (CNF1, CNF2)
• Thermistor <Outdoor pipe> (TH3)
• Thermistor <Compressor> (TH4)
• Thermistor <Outdoor 2-phase pipe, Outdoor> (TH7/6)
• High pressure switch (63H)
• High pressure sensor (63HS)
• Low pressure switch (63L)
• Solenoid valve coil <4-way valve> (21S4)
• Solenoid valve coil <Bypass valve> (SV1)
• Solenoid valve coil (Returning oil bypass)
<Bypass valve> (SV2)
(5) Remove the terminal cover and disconnect the compressor
lead wire.
(6) Remove an electrical parts box fixing screw (4 × 10) and
detach the electrical parts box by pulling it upward. The
electrical parts box is fixed with 2 hooks on the left and 1
hook on the right.
Fan motor fixing screws
Photo 2
Fan
motor
Fan motor fixing screws
Propeller
Front panel
Nut
Photo 3
Photo 4
Electrical
parts box
Controller circuit board
(C.B.)
Electrical parts
box fixing screw
Terminal cover
Cover panel
(Front)
Cover panel fixing screws
Compressor (MC)
Terminal block (TB1)
Valve bed
Screw
MXZ-8B140VA MXZ-8B140YA MXZ-8B160VA MXZ-8B160YA
Photo 1
Top panel fixing screws
Top panel
Service panel
fixing screws
Service panel
Grille
fixing
screws
Fan grille
Grille
fixing
screws
Slide
Front
panel
Photo: MXZ-8B140/160VA
OCH480A