Mitsubishi Electric MSZ-WG18VA-H1, Инструкции по эксплуатации и установке

Страница: 31 / 52

4
Important setting
4
1
2
5
3
Preparation before operation
Remote controller
HOW TO SWITCH OVER <REMOTE CONTROLLER>
How to install battery and set current time
Remove the frontal cover and install batteries.
Then, reinstall the cover. Insert the cathode of the
batteries in the first. Check if the polarity is correct.
Press the reset button.
Use sharp thing to press it.
Repress the Clock setting button and close the frontal cover.
Press (forward) and (backward) button (time
setting button), set current time.
Transmitter section
Operation display
section
Operate/stop
(ON/OFF) button
Temperature button
Fan speed control button
Horizontal
vane button
Operation select button
Econo Cool button
Wide vane button
(Vertical vane button)
Reset button
Clock setting button
Time setting button
Forward button
Backward button
OFF-TIMER button
ON-TIMER button
MOVE EYE button
Remove the
frontal cover
First, insert the negative electrode
·
If the reset button is not pressed, the remote controller
can’t work normally.
·
Note that the pressing shall not be done forcibly.
Press the Clock setting button.
Use something sharp at the end to press it.
·
Each press of the Forward button increases one minute;
Each press of the Backward button decreases one minute.
·
If you press and hold down the button for a long time, the
set time will increase/decrease in ten minutes intervals.
Long operation
Be sure to set the slide switch inside the remote controller to an appropriate position in accordance with the
installed position of the indoor unit. If the switch is not set correctly, the air conditioner may not function properly.
Area Left Center Right
Position of the slide
switch
Display on the
remote controller
Where is the indoor unit installed in the room?
(Left) (Center)
(Right)
Installed at left, (The
distance is not more
than 50cm.)
Installed at right,(The
distance is not more
than 50cm.)
Is the indoor unit installed
at right, left or center?
* If the indoor unit is installed more than 50 cm away from the side walls,
cabinets or other nearby objects, set the slide switch to the "center" position.
Switch