24
DISASSEMBLY INSTRUCTIONS
10
MSZ-GA50VA
MSZ-GA60VA
MSZ-GA71VA
MSZ-GA80VA
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
1
Slide the sleeve.
2
Pull the terminal while
pushing the locking
lever.
1
Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
OPERATING PROCEDURE
PHOTOS
1. Removing the front panel
(1) Remove the screw caps of the front panel.
Remove the screws.
(2) Pull the panel down to your side slightly and unhook the
catches at the top.
Photo 1
Photo 2
Front panel
Screw of the
cable clamp
Indoor
electronic
control
P.C. board
Vane motor
connector
Fan motor
connector
Screws
Screw of
the electrical
cover
R.L
holder
Receiver
P.C.
board
2. Removing the electronic control P.C. board, the receiver
P.C. board and the display P.C. board
(1) Remove the front panel. (Refer to 1.)
(2) Remove the screw of the electrical cover.
Remove the electrical cover.
(3) Remove the screws of the cable clamp.
Remove the cable clamp.
(4) Remove the screw of the earth wires, which is solder-
mounted to the electronic control P.C. board and connected
to the terminal block.
(5) While pulling the electronic control P.C. board forward little
by little, disconnect all the connectors from the board.
(6) Remove the R.L holder.
(7) Remove the electronic control P.C. board.
(8) Open the R.L holder, remove the receiver P.C. board and
the display P.C. board.
Screw of
the earth
wires
OB419A.qxp 06.6.5 11:09 AM Page 24
