7
FAN
VANE
MODE
ECONO COOL
STOP
START
HR.
MIN.
I FEEL COOL
DRY
RESET CLOCK
HEAT
/FAN
PREPARATION BEFORE OPERATION
3
Press the CLOCK set button.
4
Press the
HR.
and
MIN.
button
(TIME SET button) to set the current
time.
■
Each time the
HR.
button is pressed, the set time in-
creases by 1 hour, and each time the
MIN.
button is
pressed, the set time increases by 1 minute.
5
Press the CLOCK set button again
and close the front lid.
WARNING
Remove dirt from the power supply plug and insert
the plug securely.
If dirt adheres to the plug or insertion is incomplete,
it may cause a fire or an electric shock.
Press using
a thin stick.
Auto restart function
■
These models are equipped with an auto restart function, but this function is OFF
when the units are shipped from the factory. If you want to use the auto restart
function, please consult the service representative because the setting of the unit
needs to be changed.
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and
the fan speed are stored in the memory. If a power failure occurs or the main power is turned off during
operation, “Auto restart function” sets automatically to start operating in the same mode as the one set with
the remote controller just before the shutoff of the main power.
Remote controller (How to set the batteries and the current time)
Indoor unit
■
Insert the power supply plug into the
power outlet and/or turn the breaker
on.
1
Remove the front lid and insert bat-
teries. Then reattach the front lid.
Insert the minus pole of the batteries first.
Check if the polarity of the batteries is correct.
2
Press the RESET button.
■
If the RESET button is not pressed, the remote control-
ler may not operate correctly.
Remote controller (How to set the type)
■
This remote controller setting needs to be switched according to the type of air
conditioner (COOL & HEAT or COOL ONLY).
If the setting is incorrect, the air conditioner does not operate normally. Therefore,
check if the setting corresponds to the type of your air conditioner. If it does not,
correct the setting as shown below.
Type
COOL & HEAT
COOL ONLY
The position
of the slide
switch
Press using
a thin stick.
Insert the minus pole
of the batteries first.
Slide switch
