58
SET/MONITOR
SET
S M T W T F S
MONITOR
PROERAN TIMER
PAC-SC32PTA
TODAY
ON
WEEKLY
SETTING
OFF
ON
SET BACK
OFF
CLOCK
DAILY TIMER
SET BACK
SET BACK
DAILY
SETTING
12
15
18
21
24
0
3
6
12
15
FILTER
CHECK MODE
TEST RUN
Connect to indoor unit
with 2-wire cable.
Use 5-wire cable
Connect to CN1
Connect to CN1
4
1-3. How to connect program timer
(1) Install the program timer next to the remote controller the same way as the remote controller is installed.
(2) Connect the program timer and the remote controller with a 5-wire cable as shown in the figure below.
1-4. Names and functions
<PAC-SC32PTA>
NOTE:While the program timer is connected to the remote controller, the
24hour ON/OFF timer on the remote controller will not operate.
WEEKLY TIMER SETTING DISPLAY
Used for selection of if or not the day opera-
tion pattern set by PATTERN SETTING is to
be applied in weekly day unit,
setting.
SET/MONITOR
SET
S M T W T F S
MONITOR
PROERAN TIMER
PAC-SC32PTA
TODAY
ON
WEEKLY
SETTING
OFF
ON
SET BACK
OFF
CLOCK
DAILY TIMER
SET BACK
SET BACK
DAILY
SETTING
12
15
18
21
24
0
3
6
12
15
CURRENT TIME DISPLAY
During MONITOR status,current
time is display.
During Daily timer setting, a
time desire for timer setting is
displayed.
SET BACK DISPLAY
Indicates the setting set
back range.
DAILY TIMER SETTING DISPLAY
24 hours is divided into 48 blocks and each
block express 30 minutes.
The block display consists of 3 pattern.
“MONITOR” :Indicates the current timer set-
ting. All switch expect MODE
SELECTOR SW are invalidated
then.This is the normal status.
“SET”: Set to “SET” mode for clock adjust-
ment, charge of week day, daily and
weekly timer setting.
Push
SW to advance the time. Each time the button is
pushed the time advance by 1 minute, pushing continuously
advances by 1 minute at 0.5 second interval, and when the
lower digit of minute becomes 0 indication advances in 10 min-
utes unit.
SW is used for reversing the time. Each time the button is
pushed the time reverses by 1 minute, pushing continuously
reverses the time by 1 minute at 0.5 second interval, and when
the lower digit of minute becomes 0 indication reverses in 10
minutes unit.
Pushing
SW moves the week day light
display in order of
S
→
M
→
T
→
W …
enabling to set the week day.
SET BACK SETTING SW
Used for set back setting.
SET/MONITOR DISPLAY
During SET is display, clock adjustment,
change of weekly day, daily and weekly timer
setting can be performed.
During MONITOR is display, all switches
except SET/MONITOR SW are invalidated.
This is normal status.
WEEK DAY SETTING SW
Used for week day setting.
MODE SELECTOR SW
Using this switch select “MONITOR” or “SET”
Mode.
CLOCK ADJUSTMENT SW
Used for adjustment of the current time.
WEEKLY TIMER SW
Used for setting timer in day of week unit.
Set back can be done in the range of 1,2,4,6
and 8°C.
ON/SET BACK/OFF SW
Used to specify the time setting pattern.
DAILY TIMER SW
Used for timer setting in 30 minutes unit.
OC236(181A)---2.qxp 01/9/27 5:31 PM Page 58
