Before use
Operation
Cleaning
When in trouble
Support cover
Adjustment and affixing
●
Please fix the tilt by adjusting the legs.
Please adjust the adjustable leg as the following picture to level the refrigerator.
Refrigerator/front lower
If the left side
of the door
is sagging
If the right side
of the door
is sagging
Raise the right side
Raise the left side
Left
Right
Keep the front at a slightly
higher angle. This makes
closing the door easier
and prevents the door
from partially opening.
※
After several days from installing, it may sink to the floor by weight.
Please re-adjust the adjustable legs again.
When the tilt cannot be corrected
with the adjustable legs.
If installed in a corner of a room,
there are times when one side of
the back legs sinks into the floor.
When that happens, please make
adjustments in the rear with
caster support (separately sold)
or a strong board underneath
(normally, the thickness of the
board should be 2 – 3 mm.)
For the caster support, please contact
to the shop where you purchased.
Model No.: MRPR-03CS
Rear support
Caster support
or strong board
●
After adjusting please insert the toe grille.
(Toe grille included in the refrigerator)
Toe grille
Please insert in parallel until
the cover hit in depth.
Adjustable leg
Caster
Start using
●
It takes time to cool down.
•
Put in warm food items or ice
cream after the refrigerator has
been adequately cooled down.
•
Keep opening and closing of
the door for to a minimum,
and open in a short time.
•
In the summer, it will take
approx. 24 hours to make
the first batch of ice.
●
It may smell of plastic.
•
The smell will gradually disappear.
Please ensure that the room
is adequately ventilated.
●
When the refrigerator is in cooling
mode the following may occur
(also occurs during summer).
•
The side will be hot to radiate
outside of the refrigerator for cooling.
•
Operating noise may be loud
due to the compressor running
at a high speed operation.
Because a flammable
refrigerant (gas) is used,
there is the danger of
igniting or explosion.
Do not damage the
refrigerant circuit (piping)
of the refrigerator;
do not drive in screws.
Do not do
Use in hot spring areas
Corrosion control treatment must be
applied for the refrigerant circuit (pipe)
due to generation of corrosive gases.
Contact the retail store where you
purchased the refrigerator.
(to provide half-opened
door/noise/move/vibrate)
※
Before adjusting, please pull the leg cover to the front and remove it.
Turn the adjustable legs to get
them to touch the floor, then affix.
5
If the supports are not
adjusted properly, the
refrigerator may move
and cause injury.
Caution
Insert the blade of the screwdriver
Turn the adjustable supports
in the arrow direction until
they touch the floor.
Adjustable
support
Flat-blade
screwdriver
Caster
