Mitsubishi Electric MR-G57N, Руководство по эксплуатации

Страница: 22 / 32

Water tank
Water supply
pipe
Pipe junction
Pipe
Tank holder
(on the refrigerator
body)
Be careful not
to pinch any
foreign object.
While pushing the
tab downward with your
finger, pull the cover off.
Tab
Pipe
Water supply
pump
Impeller
Cap
Cover
Light-type bacteria
removing filter
Cleaning once a week
Remove the lid and wash
with water.
(the tank can withstand up to
approximately 60°C)
Pull out the pipe.
Twist the pump to remove it.
Disassemble and wash
the parts with water.
The impeller is magnetic.
Wash carefully to remove
all foreign objects.
Normally the filter need not be
replaced. However, replace it in
the following conditions:
• When the filter is clogged by
passing something other than
water through the filter
• When the filter is broken
• When the filter is moldy
In such cases, contact the retail store at
which you purchased this refrigerator.
Reverse the steps to replace the pump.
Water tank
1
2
Pipe
Improper reassembling might cause failed ice making or increased noise.
Check the following.
Fit the filter cover’s tab (
1
)
and hook (
2
) into the cap.
Align the marks on the
pipe and the water tank.
Rotate the cap and catch
the cap hook (
1
) onto the
water supply pump tab (
2
).
Securely rotate the water supply pump
into the water tank to install it.
*Make sure that no foreign object is found between
the water supply pipe and the pipe junction.
*Make sure that the impeller is in the pump.
Improper fitting or any foreign object will produce
a clearance between the pipe and the pipe junction
to cause freezing of the water tank.
Pipe
mark
Water tank
2
2
1
1
Light-type
bacteria
removing filter
Impeller
Rotate
Rotate
Water tank
Reassembly points
Water tank Water supply pump / Light-type bacteria removing filter
Cleaning once a month
Cleaning once a month
Pull out water supply
pipe. Wipe the tank
holder with clean cloth.
Separate pieces and
wash with water.
Reverse steps to
replace the pipe.
Side A
Side B
Water supply
pipe
Aluminum pipe
Packing
Water supply
pipe
Tank holder
Water supply pipe / Tank holder
Twist on the aluminum pipe to
replace it.
*The water supply pipe may be
white due to minerals or chlorine,
but this is not abnormal. Wash the
pipe and continue using it.
Do not use kitchen detergent, benzene, bleach or other cleaning
products to clean the light-type bacteria removing filter.
The products above give ice odours.
Be sure to read all instructions for detergents, bleach and other
cleaning products you use to clean the water tank and lid.
Do not let water flow into the tank holder.
Replace the water supply pipe.
Be sure that sides A and B fit flush
against each other. Otherwise, the
ice maker may malfunction if the
pipe is not installed properly.
Insert horizontally
Note
Maintenance
Maintaining the Automatic Ice Maker
22