9
6. What to do in these situations
When there’s a power failure.
Minimize opening/closing of doors and avoid putting in more food.
When not in use for a long time.
Clean the Ice cube box and Ice tray, clean the interior after unplugging the refrigerator,
and keep the door open for 2 - 3 days to let it get dry.
If not allowed to dry properly, mold and odors can occur, or refrigerant (gas)
may leak due to corrosion of the cooling unit.
When transporting.
1. Discard the water/ice from the Ice cube box and the Ice tray.
2. Use protective gear (protective gloves).
3. Lay towels under the water discharge outlet and under the back corners of the refrigerator,
and place a container or tray on the floor that’s about 3 cms high to catch water.
Do not damage the refrigerant circuit, do not drive in screws, etc.
The unit uses a flammable refrigerant, so if the gas leaks out, there is the risk of ignition or an explosion.
4. Slowly tilt the refrigerator back to an angle of over 30 degrees, discharge water
of the evaporator tray through the water discharge outlet.
5. With more than 2 persons, calmly and slowly transport the unit by grasping the
front side’s lower section legs and the back side’s upper section outer shell.
Towels prevent water from spilling on the floor and damage to the floor.
Have 2 or more persons do this work because the unit is heavy.
Avoid having young children or those without confidence do this work.
Please seek advice from a moving company.
Do not lay or load on its side (it will cause damage to the compressor.)
Water discharge outlet
Page 4
Front side - lower
section lags
Back side - upper
section outer shell
WARNING
5. Maintenance
CAUTION
Do not apply water directly onto the refrigerator.
This may result in malfunction, power leakage or fire.
Dip a soft cloth into cold or lukewarm water, wring it out well and wipe.
If you do not clean the door gasket (especially the lower part) when it is dirty, the gasket will easily become
damaged. Therefore, keep it clean at all times.
Do not clean with cleanser, acids, benzine, thinner, boiling water, soap powder, chemical cloths or neutral
detergent. These will damage the paint finish and external surfaces of your refrigerator.
When performing maintenance, make absolutely sure that the power plug is first disconnected from the power outlet.
How to Replace the LED Light
In the event that the LED light is damaged or malfunctions, please refrain from adjusting
or repairing it by yourself. Please contact the service center instead.
