Mitsubishi Electric MR-E62S, Руководство по эксплуатации

Страница: 6 / 36

6
Troubleshooting
Before Use
Operation
Cleaning
Install the refrigerator in:
A place with good ventilation not
exposed to direct sunlight or hot air
To prevent a drop in cooling performance
and to reduce power costs.
A place with low humidity
To prevent rusting, electric shock and fi re.
A strong and level place
To prevent vibration and noise, and ajar
or tilting doors.
If the refrigerator supports sink easily into
the fl oor material, lay a strong plate or
board underneath.
(To prevent deformation or discoloration
due to the weight or heat.)
A place away from other devices
To prevent noise or video interference
with devices such as televisions.
A place with at least 2 cm of
space on the left and right of
the refrigerator, and 10 cm of
space from the top.
To allow heat to dissipate from the top
and the sides of the refrigerator.
Use a dedicated outlet
Use a dedicated outlet for the power supply that meets the rating specifi ed
on the rating label. (The rating label is located on the door-liner of the
refrigerator compartment.)
The refrigerator will not be damaged even if the power is
supplied soon after installation.
It takes a while for the refrigerator to cool, therefore
supply power as soon as possible.
Electrical Connections
Make sure this unit is properly grounded.
The refrigerator should always be plugged into its dedicated electrical
outlet.
This will provide the best performance and prevent electrical circuits
from being overloaded and causing a fi re.
Make sure that the electrical outlet provides the proper voltage.
Extension cords are not recommended.
If your refrigerator is installed in the high humidity location, not only
ground connection but also installation of the earth leakage breaker is
recommended.
If the power cord is damaged, purchase a new cord from MITSUBISHI
SERVICE CENTER. Make sure that the power cord is designed for this
model.
If the power cord is damaged, call our MITSUBISHI SERVICE CENTER
for the replacement, in order to avoid a hazard.
Installation
1
The outside of the refrigerator and the
rotating partition get hot.
Cooling takes time after turning
on the refrigerator.
Connect the power supply
* Connect power supply soon after installing the refrigerator
2
Warning
Using outlets that do not meet the specifi ed rating or plugging in too
many leads into a single socket can cause heat buildup or fi re.
Warning
Do not obstruct the refrigerator vents
or the space around the refrigerator.
If refrigerant leaks, it may accumulate
and catch fi re or explode.
Rotating
partition
• Wait until the refrigerator has fully cooled before storing
non-cooled food or ice cream.
• Do not open the doors more than necessary, and close
them as soon as possible.
At least 5 cm
In the summer, it may take more than 24 hours.
Heat dissipation causes
the temperature to rise to
about 50°C to 60°C when
operation is fi rst started,
and during the summer. The
rotating partition may get hot
when heated by the heater.
When making ice for the fi rst time
A gap of
at least 10 cm
Dedicated
outlet that meets
the specifi ed rating.
A gap of
at least 2 cm
Turn on the power of the
refrigerator as soon as
possible.
The refrigerator will not be
damaged even if you turn on
the power immediately after the
installation.
From Installation
to Operation
MR-E62S.indb 6 2011/09/09 17:15:14