Mitsubishi Electric MJ-E14CG-S1-SWE, Инструкция по эксплуатации

Страница: 16 / 28

1
The louvre can be made to swing. Select from the 4 possible settings to suit the purpose.
Press

Starts swing operation.

The swing monitor is displayed.
The swing operation stops when the power
cord is unplugged.
Using Louvre
(how to read the swing monitor)
This indicates the range of louvre swing.
(The louvre and monitor do not move in
synchronization.)
With each
press of the
button
Stop swing
operation
WIDE
UPWARD
REAR
Objective Recommended swing setting Explanations of the swing modes
To stop the
louvre at the
desired angle

Stop swing
operation
The louvre stops in a vertical position.
The swing monitor turns off.
To change the louvre to a desired angle, wait until the
louvre stops, then adjust by hand.
l
l
To cover the
entire room

WIDE
The louvre swings from the UPWARD position through to
the REAR position.
For drying
clothes, etc.

UPWARD
Swing speed is automatically controlled to send air at
washing from all angles.
For directing air
into a closet

REAR
The louvre moves slowly through
the last 30° of the swing, as the
time taken to traverse the rear arc
is shorter than that for the upward
arc when moving at a constant
speed.
Information
The level of noise emitted from the unit varies according to the angle of the air-flow.
The louvre may stop up to a maximum of 8 seconds to correct its position, after which it will start moving again.
If the louvre is knocked out of the desired angle, readjust by following the above steps.
l
l
l
Note
Stop the louvre in the vertical position when using the unit against a wall. Blowing air at the wall may cause staining.
e_mj_e14cg_s1_swe.indb 16 2013/12/19 20:32:41