Mitsubishi Electric MELSOFT FR Configurator2, Инструкция по эксплуатации

Страница: 140 / 230

139
3. FUNCTION
3.4 Graph
1
2
3
4
5
6
7
8
9
10
 700 series
NOTE
• When changing the sampling setting mode (monitor/high speed), change the sampling items before setting. Because the
monitor contents change if the mode is changed, unshared sampling items are cleared. (Refer to page 139 .)
• When setting sampling items, set analog data (CH1 to CH4) sequentially from the analog data CH1, and digital data (CH1 to
CH4) sequentially from the digital data CH1.
• When the position command, current position, or droop pulse is sampled, the upper and lower sets of data are combined to
display a waveform, occupying two channels. For the latter of the two channels, "Unselected" is shown and another item
cannot be selected to display a waveform.
• When sampling the voltage input of terminal 2, terminal 4, and terminal 1, Pr.241 Analog input display unit switchover will
be set to "0" (% display), and the sampled data will be shown as 10 V = 100%.
Example: If
Pr.73 = 1 (Terminal 2 input 0 to 5 V), Pr.241 = 0 (% display)
Sampling data of the graph will be shown at 50% even if 5 V is input to terminal 2.
3.4.4 Trigger settings
Setting a trigger allows sampling to start when an alarm occurs or sampling item conditions are met.
Sampling item
Model
E700 and E700-NE
E700EX D700-G
USB Ethernet
*Output frequency / *rotation
speed
○ × ○ ×
*U-phase output current ○ × ○ ×
*V-phase output current ○ × ○ ×
*W-phase output current ○ × ○ ×
*Converter output voltage ○ × ○ ×
*Output current (for all three
phases)
○ × ○ ×
*Excitation current (A) ○ × ○ ×
*Torque current (A) ○ × ○ ×
Terminal 2 ○ × ○ ×
Terminal 4 ○ × ○ ×
*Excitation current (%) × × ○ ×
*Torque current (%) × × ○ ×
*Position command (before the
electronic gear)
× × ○ ×
*Current position (before the
electronic gear)
× × ○ ×
*Droop pulse (after the
electronic gear)
× × ○ ×
*Position within one revolution × × ○ ×
*Ideal speed command × × ○ ×
*Rotation speed (signed) × × ○ ×
*Motor speed × × ○ ×
*Speed command × × ○ ×
*Excitation current command × × ○ ×
*Torque current command × × ○ ×
B
A
C
D
E