Mitsubishi Electric MELFA RH-FRH-D, Описание установки

Страница: 68 / 166

Grounding the robot system Installation
3 - 30
3.6 Grounding the robot system
General instructions on grounding the robot system
Three ways of grounding are shown in Fig. 3-24.
●
Separate grounding is the best solution.
– The robot arm is grounded at an M4 threaded hole (see Tab. 3-8) on the base area.
– The controller is grounded together with the mains line (feed) connection.
To ground the controller, proceed as described in Section 4.2.
●
If possible, the grounding of the robot arm must be separated from other units/devices.
●
The minimum cross-section of the grounding cable must be 4,2 mm².
●
The grounding cable is not included in the scope of delivery of the robot system.
●
The grounding cable should be kept as short as possible.
R000451E
Fig. 3-24:
Grounding the robot system
Robot arm
separate grounding
(best solution)
Controller
and personal
computer
Robot arm Robot arm
Controller
and personal
computer
Controller
and personal
computer
parallel grounding
(good solution)
common grounding
(permissible)