Mitsubishi Electric fr-e700 series, Инструкция по эксплуатации

Страница: 300 / 608

Monitor display and monitor output signals Parameter
6 - 146
Cumulative energizing power monitor and clear (Pr. 170)
On the cumulative power monitor (Pr. 52 = "25"), the output power monitor value is added up and is
updated in 1h increments. The operation panel, parameter unit (FR-PU04/FR-PU07) and communi-
cation (RS-485 communication, communication option) display increments and display ranges are as
indicated below:
햲
Power is measured in the range 0 to 9999.99 kWh, and displayed in 4 digits.
When the monitor value exceeds "99.99", a carry occurs, e.g. "100.0", so the value is displayed in
0.1 kWh increments.
햳
Power is measured in the range 0 to 99999.99 kWh, and displayed in 5 digits.
When the monitor value exceeds "999.99", a carry occurs, e.g. "1000.0", so the value is displayed in
0.1 kWh increments.
Writing "0" to Pr. 170 clears the cumulative energizing power monitor.
Cumulative energizing time and actual operation time monitor (Pr. 171, Pr. 563, Pr. 564)
Cumulative energization time monitor (Pr. 52 = "20") accumulates energization time from shipment
of the inverter every one hour.
On the actual operation time monitor (Pr. 52 = "23"), the inverter running time is added up every hour.
(Time is not added up during a stop.)
If the monitored value exceeds 65535, it is added up from 0. You can check the numbers of cumulative
energization time monitor exceeded 65535 h with Pr. 563 and the numbers of actual operation time
monitor exceeded 65535 h with Pr. 564.
Writing "0" to Pr. 171 clears the cumulative energization power monitor. (The cumulative time mon-
itor can not be cleared.)
Operation Panel
햲
FR-PU04/FR-PU07
햳
Communication
Range Unit Range Unit
Range
Unit
Pr. 170 = 10 Pr. 170 = 9999
0–99.99 kWh 0.01 kWh 0–999.99 kWh 0.01 kWh
0–9999 kWh
0–65535 kWh
(initial value)
1 kWh 100–999.9 kWh 0.1 kWh 1000–9999.9 kWh 0.1 kWh
1000–9999 kWh 1 kWh 10000–99999 kWh 1 kWh
Tab. 6-38: Units and range of the cumulative energizing monitor
NOTE If "0" is written to Pr. 170 and Pr. 170 is read again, "9999" or "10" is displayed.
NOTES
The actual operation time is not added up unless the inverter is operated one or more hours con-
tinuously.
If "0" is written to Pr. 171 and Pr. 171 is read again, "9999" is always displayed. Setting "9999" does
not clear the actual operation time meter.