3/4
4/4
(4) Install the control circuit terminal block of the FR-A700/A500 series inverter. Be careful not to bend
the pins of A8TAT control circuit connector. Fix the control circuit terminal block using the installation
screws of the control circuit terminal block. (Tightening torque: 0.33 to 0.4 N
m)
3
Restrictions for using the inverter with the A8TAT
• For using the control circuit terminal block of the FR-A500 series, open or remove the cover of the
control circuit terminal block. Otherwise, the front cover of the inverter may not close properly.
• Since the specifications of the control circuit terminals of the FR-A700/A500 series are different from
those of the FR-A800 series, certain functions of the inverter are restricted (refer to the table below).
...Available
...Not available
• The FR-A8NC or FR-A8NCE plug-in option cannot be used.
• When using a plug-in option, connect the plug-in option using a cable that can be routed through the
space between the the front cover and the control circuit terminal block (FR-A700 series: 7 mm, FR-
A500 series: 0.8 mm).
REVISIONS
Relay output 2
terminals
24 V external power
supply input terminal
Safety stop
signal terminals
FR-A500
series
FR-A700
series
Fix with screws.
Print date
* Manual number
Revision
May 2014
IB(NA)-0600541ENG-A
First edition
HEAD OFFICE: TOKYO BUILDING 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
