Mitsubishi Electric FR-A700 EC, Инструкция по эксплуатации

Страница: 161 / 826

Basic settings PU operation mode
FR-A700 EC 5 - 41
5.2.1 Set the set frequency to operate
Possible faults:
●
Operation cannot be performed at the set frequency.
– Did you press the SET key within 5s after turning the digital dial?
●
The frequency does not change by turning the digital dial.
– Check to see if the operation mode selected is the external operation mode. (Press the
PU/EXT key to change to the PU operation mode.)
●
Operation does not change to the PU operation mode.
– Check that "0" (initial value) is set in Pr. 79 Operation mode selection.
– Check that the start command is not on.
Change the acceleration time using Pr. 7 (refer to section 5.1.5) and the deceleration time using
Pr. 8 (refer to section 5.1.5).
The maximum output frequency is set in Pr. 1. (Refer to section 5.1.4).
쑶
Example
쑴
Performing operation at 30Hz
I001070E
Fig. 5-17: Frequency setting with the digital dial
NOTES Press the digital dial to show the set frequency.
The digital dial can also be used like a potentiometer to perform operation. (Refer to
section 5.2.2.)
Screen at powering on
The monitor display appears.
Press the PU/EXT key to choose the
PU
operation mode.
Turn the digital dial to show the
frequency you want to set.
The frequency flickers for about 5s.
While the value is flickering press the
SET key to set the frequency.
(If you do not press the SET key, the
value flickers for about 5s and the
display returns to 0.00 (display) Hz.
At this time, return to step
and set
the frequency again.)
After the value flickered for about 3s,
the display returns to 0.00 (monitor
display). Press the FWD (or REV) key
to start operation.
To change the set frequency, perform
the operation in above steps
and .
(Starts from the previously set
frequency.)
Press the STOP/RESET key to stop.
Operation Display
Flickers for about 5s.
Flicker ... Frequency setting complete!
PU indication is lit.
3s later