Mitsubishi Electric Diamond Pro 930SB, Руководство по обслуживанию, Страница: 13 / 187

1-9
7
Controls
–continued
GlobalSync ® Control: Eliminates picture impurities that may result from the
earth’s magnetic field. While in the sub-menus ( TL: Top Left, TR: Top Right, BL:
Bottom Left, or
BR
: Bottom Right) use the –/+ control buttons to fine tune the
GlobalSync corrections.
NOTE:
Mitsubishi recommends that you perform GlobalSync correction while
running a typical application such as a spreadsheet or text document.
Tools 2
Language: OSD controls menus are available in six languages.
OSD Position:
You can choose where you would like the OSD controls menu to
appear on your screen. Selecting OSD Position allows you to manually adjust the
OSD controls menu left, right, up or down.
OSD Turn Off:
The OSD controls menu will stay on as long as it is in use. In the
OSD Turn Off sub-menu, you can select how long the monitor waits after the last
touch of a button for the OSD controls menu to disappear. The preset choice is in
5 seconds step between 5–120 seconds.
OSD Lock Out : This control completely locks out access to all OSD controls func-
tions except Brightness and Contrast. When attempting to activate OSD controls
while in the lock out mode, a screen will appear indicating that OSD controls are
locked out. To activate the OSD Lock Out function, press SELECT , then press + and
hold down simultaneously. To deactivate the OSD Lock Out, press
SELECT
, then
press + and hold down simultaneously.
IPM ™ System Off Mode: Enable: The IPM System works normally and all
stages of energy savings are utilized.
Disable: The Off Mode reset
NOTE: For standard systems and graphics boards, keep the factory setting at ENABLE.
NOTE: Don’t keep the Diamond Pro monitor on when ‘No Signal’ is applied. This could cause
image burn in on the screen due to the ‘No Signal’ message being displayed.
EdgeLock ™ Control: Operating your monitor at a nonstandard timing may cause
images to appear darker than normal or have color distortion. Use of the
EdgeLock control will adjust images to their normal state.
Hot Key: This selection allows you to use as brightness control and –/+
as contrast control.
Factory Preset:
Selecting Factory Preset allows you a reset most OSD
™
control
settings back to the factory settings. A warning statement will appear to confirm
that you do want to reset ALL settings. Individual settings can be reset by high-
lighting the control to be reset and pressing the RESET button.
Information
Display Mode:
Indicates the current mode and frequency setting of the monitor.
Monitor Info: Indicates the model and serial numbers of your monitor.
Refresh Notifier: A message will advise you if the refresh rate of the signal being
applied to the monitor by the computer is too low. For further information, please
refer to your display card or system manual.