Mitsubishi Electric CITY MULTI PEFY-WP10VMS1-E, Техническое и сервисное руководство

Страница: 20 / 34

[
VII
Troubleshooting ]
- 16 -
HWE1209A GB
5. Dipswitch setting (Factory setting)
1. Function setting
(1) SW1
1) Adress board
(2) SW3
1) Indoor control board
Dipswitch settings must be made while the unit is stopped.
Switch position Function Switch setting
ON OFF
1 Active Thermistor (Intake air
thermistor)
Built-in thermistor on the remote
controller
Indoor unit
2 Filter clogging detection Available Unavailable
3 Filter life 2500 hr 100 hr
4 Outdoor air intake Enabled Disabled
5 Remote display Thermo-ON signal Fan output
6 Humidifier operation During heating mode During heating operation
7 Fan speed Low Very low
8 Fan speed at heating Thermo-OFF Preset fan speed Follows the setting of SW1-7
9 Auto restart after power failure Enabled Disabled
10 Power start/stop Enabled Disabled
Factory setting
ON
1 2 3 4 5 6 7 8 9 10
Switch position Function Switch setting
ON OFF
1 Unit type Cooling only Heat pump
2 - - -
3 - - -
4 - - -
5 - - -
6 - - -
7 - - -
8 Heating 4-deg up Disabled Enabled
Factory setting
ON
1 2 3 4 5 6 7 8 9 10
ON
1 2 3 4 5 6 7 8 9 10
The figure at left shows that the switches 1 through 5 are set to ON and 6 through 10 are set to OFF.
HWE1209A.book 16 ページ ２０１７年３月９日 木曜日 午後５時３７分