6
GB
Operation mode icons
Cool
Fan
Auto
Heat
Auto Cool
Auto Heat
Turning ON and selecting operation mode
1
Press button
1
[ON/OFF].
The ON/OFF lamp and the LCD will light up.
2
Press button
7
[F1] to go through the operation modes.
Cool
*1
Fan
Auto
*1*2
Heat
*1
*1 Operation modes that are not available to the connected indoor unit models will not appear on the display.
*2 Single or dual set points will appear, depending on the indoor unit model.
* Interlocked operation is performed in all the operation modes when the ventilation unit is interlocked.
Preset temperature setting
Preset temperature will be displayed either in Celsius in 0.5- or 1-degree increments, or in Fahrenheit, depending on the indoor unit model and the display mode
setting on the remote controller.
<Cool, and Heat>
Press button
8
[F2] to decrease the preset temperature.
Press button
9
[F3] to increase the preset temperature.
<Auto (dual set point)>
1
Press button
8
[F2] or
9
[F3].
2
Press button
7
[F1] or button
8
[F2] to
move the cursor to the desired
temperature setting (cooling or heating).
Press button
9
[F3] to decrease the
selected temperature, and
0
[F4] to
increase.
F1
F2
F3
F4
Auto
Auto
Mode
Temp.
Fan
Fri
F1
F2
F3
F4
Main display:
Cursor
Set Temp.
Temp.
Fan speed setting
Press button
0
[F4] to go through the fan speed.
* The number of available fan speeds depends on the model.
<Note>
The actual fan speed will be different from the fan speed displayed on the LCD when one of the
following conditions is met.
While "Standby" or "Defrost" is displayed
Right after the heating operation (during stand by for switching the operation mode)
Preset temperature
for cooling
Preset temperature
for heating
