Mitsubishi Electric CC-Link IE Field NZ2GF12A-60IOLH8, Руководство пользователя

Страница: 47 / 162

6 Parameter Setting
6.1 CC-Link IE Field Network Parameter Setting
45
6
6
Parameter Setting
This chapter describes the procedure for setting parameters of the IO-Link module.
6.1
CC-Link IE Field Network Parameter Setting
Setting via the engineering tool
Set the parameter of the IO-Link module with the network parameter written to the CPU module of the CC-Link IE Field
Network master station. For details on setting the CC-Link IE Field Network master station, refer to the following.

User's manual for the master/local module used
Setting procedure
1.
Open the "CC IE Field Configuration" window.
For the master/local module RJ71GF11-T2
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2]  [Module Parameter]  [Basic Settings]

[Network Configuration Settings]
2.
Select an IO-Link module from "Module List", and drag and drop it to the list of stations or the network map.
3.
Configure the IO-Link module settings.
*1 Note that necessary points vary depending on the connected IO-Link device.
For details, refer to the manual of the IO-Link device.
(1) List of stations
(2) Network map
Item Description
STA# Set the station number of a slave station to be connected to the network.
The station number need not be a serial number. (Must not be overlapped.)
Station Type Set "Intelligent Device Station".
RX/RY Setting Set RX and RY assignment. For IO-Link modules, set 80 points or more.
RWw/RWr Setting Set RWw and RWr assignment in units of four points. For IO-Link modules, this setting should be
determined by the functions used.
• IO-Link mode: 4 to 132 points (IO-Link module main: 4 points, process data: 0 to 128 points)
*1
• SIO mode: 4 points
Reserved/Error Invalid Station/System Switching
Monitoring Target Station Use this to set the slave station as an error invalid station or a switching monitoring target station.
(1)
(2)