27
WT07137X02
7. Wiring connections
7-1. Removing/reinstalling the service cover
Unscrew the fixing screw on the service cover and unhook the hooks to remove it as shown in the figure below.
To replace the service cover, hook the hooks and screw the fixing screw back in.
Note
● When routing the cables from the bottom, cut out the knockout holes, cut a slit in the supplied rubber bushings to insert the
cables without the gap, and attach the bushings to the knockout holes.
● If the wall is 10 mm (13/32 in) or thicker, route the cables from the cable holes on the back.
Knockout hole for
power cables
Service cover
Hook
Fixing screw (M3 × 6)
Knockout hole for M-NET transmission
cables
Cable hole for power cables
Cable hole for M-NET transmission cables
