Mitsubishi Electric 800 Series, Инструкция по эксплуатации, Страница: 88 / 727

Basic operation procedure (External operation)
BASIC OPERATION
87
4
Parameters referred to
Pr.4 to Pr.6 (Multi-speed setting) page 314
Pr.7 Acceleration time, Pr.8 Deceleration time page 269
Pr.178 STF terminal function selection page 415
Pr.179 STR terminal function selection page 415
Pr.79 Operation mode selection page 291
4.3.2
Setting the frequency by switches (multi-speed
setting) (Pr.4 to Pr.6)
POINT POINT
• Switch ON the STF (STR) signal to give a start command.
• Turn ON the RH, RM, or RL signal to give a frequency command. (Multi-speed setting)
[Connection diagram]
NOTE
• When both the forward rotation switch (STF) and the reverse rotation switch (STR) are ON, the motor cannot be started. If
both are turned ON while the inverter is running, the inverter decelerates to a stop.
• The terminal RH is initially set to 60 Hz. The terminal RM is set to 30 Hz, and the RL is set to 10 Hz. (To change, set Pr.4,
Pr.5, and Pr.6 .)
• In the initial setting, when two or more of multi-speed settings are simultaneously selected, priority is given to the set
frequency of the lower signal.
For example, when RH and RM signals turn ON, RM signal (
Pr.5 ) has a higher priority.
• Maximum of 15-speed operation can be performed.
Parameters referred to
Pr.4 to Pr.6 (Multi-speed setting) page 314
Pr.7 Acceleration time, Pr.8 Deceleration time page 269
Changing example Operate at a high-speed (60 Hz).
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Setting the frequency
Turn ON the high-speed switch (RH).
3.
Start → acceleration → constant speed
Turn ON the start switch (STF or STR). The frequency value on the indication increases in Pr.7 Acceleration time, and
"60.00 Hz" appears. [FWD] indicator is on during the forward rotation, and [REV] indicator is on during the reverse rotation.
• When RM is turned ON, 30 Hz is displayed. When RL is turned ON, 10 Hz is displayed.
4.
Deceleration → stop
Turn OFF the start switch (STF or STR). The frequency value on the indication decreases in Pr.8 Deceleration time, and
the motor stops rotating with "0.00 Hz" displayed. [FWD] or [REV] indicator turns OFF. Turn OFF the high-speed switch
(RH).
Forward rotation start
RM
STF
STR
RH
SD
RL
Inverter
Switch
Reverse rotation start
High speed
Middle speed
Low speed
ON
ON
ON
Output frequency (Hz)
Speed 1
(High speed)
Speed 2
(Middle speed)
Speed 3
(Low speed)
Time
RH
RM
RL