12
1. Basic Setup and Operation
Setting Up Other Inputs
Connect your devices to the TV, making note of
1.
which TV input jack is used for each device. See
“TV Connections,” page 16, for recommendations.
Power on the devices to ensure detection.
2.
Power on the TV.
3.
The TV will display the
New Device Found
screen
for each new connection it detects Learn more
about Auto Input/Auto Output Sensing on the
opposite page.
Select the device type if the device is not recog-
4.
nized automatically.
Sample New Device
Found screen.
153 and 249 Series.
5.
You can perform NetCom-
mand IR “learning” after selecting the device type
or at a later time when convenient. To perform now,
highlight
NetCommand
and press
ENTER
. See
“Initial NetCommand Setup,” page 57 or “Setting Up
A/V Receiver Control,” page 62.
Important Note for NetCommand IR Users
153 and 249 Series.
Be sure to select the correct
device type here. Although you can change the
device type later in the
Inputs
>
Name
menu, any
“learned” NetCommand IR codes will be erased
when you make the change.
Press
6.
BACK
to close the
New Device Found
screen.
The TV will then display the
New Device Found
screen for the next connection it finds.
Channel Scan for Digital Channels
If you skip this step, the TV cannot receive digital
channels.
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV’s
ANT
input. Refer to page 21.
You must perform a channel scan to enable reception
of all available high-definition and standard-definition
digital channels. The channel scan will search for
channels available locally and save them to memory.
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
Power on the TV.
1.
Press
2.
MENU
and open the
Initial > Channel
menu.
Start channel memorization from the Initial > Channel
menu.
Press
3.
ENTER
to enter the menu.
Select
4.
Ant Air
if connected to an
over-the-air antenna. Select
Ant
Cable
for direct cable (service
without a cable box).
Highlight
5.
Scan
and press
ENTER
.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press CANCEL
.
Use the
Initial > Channel
>
Edit
menu (page 48) for
additional channel options, such as adding or deleting
channels from memory.
Setting Up TV Inputs
Downloaded From TV-Manual.com Manuals
