271MT / 281MT Multi-Tool
17
Original Instructions Version June13
Replacing the Nylon Cord
Check to see if the nylon head is damaged before replacing the cord. If you can see serious traces of wear or
damage, you must replace the complete nylon head.
1. Stop the engine
2. Open the nylon head by pushing on the catch, (a), and twisting the cover anti-clock wise.
3. Pull the bobbin out of the nylon head and take out the rest of the nylon cords.
4. Cut the cord, 2.4mm Ø and 5 meters long into two equal lengths.
5. Make a loop folded at one end of each of the two nylon cords and insert these into the two holes
provided on the bobbin, (b). Wind the lines clockwise maintaining an even and firm tension onto the
bobbin, being careful not to twist the line.
6. After winding the cord, insert both ends into the notches on the bobbin, (c).
7. Introduce each end of the cords into the holes provided (d). The cords should stick out appx 15 cm
either side.
8. Pull the cords to free them from the notches and refit the spool cover.
Never use a cutting device other than those supplied by the manufacturer. (Steel cord is never allowed)
Always use original spare parts in order to benefit from continuous warranty.
(a)
(b)
(c)
(d)
