Miteq D-9301, Руководство по эксплуатации и обслуживанию, Страница: 23 / 86

3-4
3.3 OPERATING PROCEDURE
3.3.1 LOCAL OPERATION (See Figure 3-1)
When remote control is installed, the front panel "REMOTE" switch
selects either Local (front panel) or Remote mode of operation.
Depressing the "REMOTE" panel switch will place the converter in
the remote operation mode. A LED on the panel will light to
indicate remote mode. Commands are accepted through the rear
panel remote interface connector (J6). All front panel function
and data entry keys (except "REMOTE") are disabled and if
pressed, will cause the error tone to sound.
To return to local operation, depress the "REMOTE" panel switch
again. The LED on the panel will not be lit to indicate local
mode. All command inputs are from the front panel. The unit
will not accept instructions through the remote interface
connector (J6) but will report frequency, mode and status.
3.3.1.1 Set Frequency
To set the frequency of the converter:
A. Enter the desired frequency (in MHz) using the numbered
keys and the decimal point.
B. Press "ENT".
3.3.1.2 Channel Memory
The converter has thirty memories for frequency settings numbered
00 to 29.
To store a frequency in memory:
A. Enter the desired frequency (in MHz) using the
numbered keys and the decimal point.
B. Press "STR" and enter the memory number using the
numbered keys (two digits). The "MEMORY" LED will
be on during the key sequence.
To recall a frequency from memory:
A. Press "RCL".
B. Enter the memory number using the numbered keys
(two digits). The "MEMORY" LED will be on during
the key sequence.