Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 566 / 585

MiVoice Office 250 Installation and Administration Guide
538
Phone : The Phone Configuration page shows information related to the phone setup and whether
the phone is currently in SIP mode. This page contains the fields described in Table 88 . To apply
the changes, click Update .
Trace : The Trace Configuration page allows you to setup a remote trace capture for UDP debug
information. The available fields vary depending on the mode the phone is in. This page contains
the fields described in Table 89 . To apply the changes, click Update .
Table 88: IP Phone Web Interface Configuration Page
Field Name Default Indicates
Image Version N/A The image version of the phone-specific code (for
example,
xxxx
_image_ver=1-2-13 (where the
xxxx
indicates the model name, such as the 8662 phone).
Image URL xxx.xxx.xxx.xxx/image/imag
e-<ss>.bin. The <ss> is the
image version from
“xxxx_image_ver .”
The IP address or URL (up to 79 digits) of the image
TFTP server. Required if the DHCP does not provide the
TFTP address.
You can also include the path to the profile file, if desired.
For example, if the TFTP server IP address is
“192.168.200.150” and the path file is “/image,” then you
can specify the URL as
“192.168.200.150/image/image-1-3-4.bin.”
IC Dial Plan xxxx (For SIP Mode Only) The dial plan mask that this phone
uses to determine valid dial strings for end of dialing for
IC, trunk, or outgoing calls. If the syntax is bad, you
cannot dial calls. The acceptable symbols for a dial plan
are described in the following table.
Trunk Dial Plan 9xxx
Outgoing Dial Plan [2–9]xxxxxxxxx|1[2–
9]xxxxxxxxx|011[1–
9]xxxxxxxxxxxxxxx
(This means that a dial plan
can accept any 10-digit dial
strings that begin with a “2”
up to “9,” any 11-digit dial
strings that begin with a “1”
and any digit “2” through “9,”
or any 18-digit dial strings
that begin with “011” and any
digit “1” through “9.”)
Hold Reminder Time 20
(For SIP Mode Only)
The time from when a call was put
on hold until the reminder or recall splash tone occurs.
SIP Mode Disabled Whether the phone will be in SIP mode or ITP mode after
the next reset. The preferred method for changing
between SIP and ITP mode is through the Web interface.
Symbol Meaning
0–9 Digit 0–9.
x Any digit 0–9.
*, # Dialpad entry (*, #).
| Expression inclusive OR.
+ Zero or more of the preceding digit(s) or
[ ] expression. For example, “+#” means
that a dial plan can accept any dial string
that ends with “#,” such as “1234*#” or “#”
(zero digits). Also “[2-9]+#” means that a
dial plan can accept any dial string that
begins with any digit “2” through “9”
followed by “#.”
[ ] Symbol inclusive OR.
- Used only with [ ]. Represents a range of
acceptable symbols.