| LZT 102 4163 | Uen | R2A | 2014-11-28 |
3.7
SYSTEM DEPENDENT PHO
Message Waiting Memory (MWM)
The message waiting memory normally stores the number to reach the voicemail box
Save MWM
1. Place the handset on the phone and
2. Press
and enter the number to be saved
3. Press
key again to complete saving
Dial from a MWM
1. Pick up the handset or press ‘Speaker/Handset’
2. Press the
Delete MWM
1. Place the handset on the phone
2. Press
3. Press
Message Waiting LED
When there is a message, the message waiting LED will be lighted ON or flashing in blue. When
there’s message waiting to be read, the
The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode
(HV / + / -). Please check the MW type of the connected PBX to work with the phone. Select “OFF” on
the MW switch to deactivate the message waiting function.
message waiting switch position.
Set Flash time
Some systems require a different flash time for the flash key. To change the flash time, proceed as
follows:
1. Press
> PHONE SETTING > SET FLASH TIME
2. Press or to select the needed flash time
3. Press
or
to confirm
Parameters
Programming key sequence
Set flash
time
[save]+[#]+[0]+[1]+[#]+
SYSTEM DEPENDENT PHONE SETTING
Message Waiting Memory (MWM)
iting memory normally stores the number to reach the voicemail box
Place the handset on the phone and press
enter the number to be saved
key again to complete saving
or press ‘Speaker/Handset’
Place the handset on the phone
When there is a message, the message waiting LED will be lighted ON or flashing in blue. When
there’s message waiting to be read, the message waiting LED will be lighted ON or flashing in red.
The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode
). Please check the MW type of the connected PBX to work with the phone. Select “OFF” on
he MW switch to deactivate the message waiting function. If the LED is steady active, change the
message waiting switch position.
Some systems require a different flash time for the flash key. To change the flash time, proceed as
> PHONE SETTING > SET FLASH TIME
to select the needed flash time
to confirm
Programming key sequence
Lock
Protected
Valid
Settings
save]+[#]+[0]+[1]+[#]+[X]+[#]
Yes
1: 100ms
2: 200ms
3: 300ms
4: 400ms
6: 600ms
9: 900ms
Mitel 7187 User Guide – R2A
25
iting memory normally stores the number to reach the voicemail box
.
When there is a message, the message waiting LED will be lighted ON or flashing in blue. When
message waiting LED will be lighted ON or flashing in red.
The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode
). Please check the MW type of the connected PBX to work with the phone. Select “OFF” on
If the LED is steady active, change the
Some systems require a different flash time for the flash key. To change the flash time, proceed as
Settings
Default
100ms
200ms
300ms
400ms
600ms
900ms
100ms