Original Instructions: 001059 DRAFT
19
Twin-Axis
Sheating Saw: Operation
3. Select
Semi Auto
on the home screen.
4. Enter the dimensions for one finished piece.
5. Load the correct material onto the infeed conveyor at or behind the
marked line.
6. Select
ClampSheet
button to push the material against the fence.
7. Select
StartCycle
and wait for the material to be processed. The ejectors
will automatically lift the material once it leaves the saw chamber.
8. When ejection movement has stopped, remove the cut material from the
outfeed conveyor and transport it to the next stage in your process.
9. If there is remaining material, either:
• Manually remove it or;
• Select
Recycle
to return the material via the conveyors to infeed side for
further processing.
Using Auto Mode
Figure Figure 4-12 shows the Auto screen with example measurements included.
Figure 4-12: Auto Main Screen
Operating in Auto
1. Complete the Daily Startup steps at the beginning of each shift
(
page 14).
2. Verify that there is no sheathing inside the saw.
3. Find the job file in
ShopNet
and select it.
Return to mode
selection screen
Status indicator
and menu
Toolbar
Rip Width (first) and
Cross-Cuts (subsquent)
Active cut
Next cut
List of active
Cross-cuts
Loads cut files
from ShopNet