MITECH MT-1C, Руководство пользователя, Страница: 4 / 5

3
mvip@mitech-ndt.com
4.2 Main body structure
1
Shell
2
Key board
3
Screen
4
Plug interface and connecting line
5
Nameplate
6
Battery cover
7
Power socket
8
Charging socket
5 Operation
1
Connect electromagnetism yoke in shutdown mode.
2
Press to open.
3
Turn on the magnet yoke.
4
Start testing.
6 Setting introduction
6.1 Lighting mode
When starting up, it will show power quantity, lighting method, brightness and power. Press up “ ” or
down “ ” to move the yellow cursor “ ” on brightness to adjust, then press “ ” to turn the color to
red “ ”. Press right “ ” and left “ ” to switch the lighting mode, then press “ ” to confirm. It shows
“ ” when the lighting mode shut down.
6.2 Brightness adjustment
When lighting method turned on, you can adjust the brightness. Press up “ ” or down “ ” to move
the yellow cursor “ ” on brightness, press “ ” to turn the color to red. “ ”. Press right “ ” to
increase signal strength and press left “ ” to decline according to the requirements, then press “ ” to
confirm.
6.3 Power regulation
Press down ” ” to move the yellow cursor on power and press “ ” to turn it to red “ ”, then adjust
the power. Press left “ ” to decrease and press right “ ” to increase according to the requirements.
Than press “ ”to confirm. The more power, the more intensive the magnetic is.
7 Maintenance
MITECH magnetic particle flaw detector is precision detector, please pay attention to the following items,

Use soft cloth to clean the detector.

Avoid strong vibration, place in dry area.

When not using for a long time, you should charge it every three months to avoid damping the
components.

Do not press the key too hard or use metal to knock it.

After turning off the detector for 5s, boot again, do not boot immediately.
8. Troubleshooting

Plug and unplug the cable line in shut down state.

Do not over charge. It takes 4-6 hours to charge. Red light means in charging. Green light means
full.

Horseshoe shape cautions: make sure turning joint and work piece well connected in shut down
state. Switch off when stop testing. Lubricate the turning joints regularly.