11
mvip@mitech-ndt.com
3) Press the
key on the desired file. It will automatically delete the file, and display “-DEL”.
4) Press the
key, at any time, to exit the data logging function and return to measurement mode.
Note
：
Do not shut down the instrument while deleting data. It could lead to unpredicted
consequence if shutting down while deleting.
5.7 System Reset
Press down the
key while powering on the instrument will restore factory defaults. The only time this
might possibly helpful is if the parameter in the gauge was somehow corrupted.
5.8 EL Backlight
With the EL background light, it is convenient to work in the dark condition. Press key
to switch on or
switch off the background light at any moment as you need after power on. Since the EL light will
consume much power, turn on it only when necessary.
5.9 Auto Power Off
The instrument features an auto power off function designed to conserve battery life. If the tool is idle
(neither measuring nor any key operation) for 5 minutes, it will turn itself off. Before powering off, the
LCD display of the instrument will continue flashing for 20 seconds. Except key
, press any key could
stop the twinkle of LCD screen and stop the operation of power off at the moment.
While the voltage of the battery is too low, the display will show <E00>, then power off automatically.
5.10 Battery Replacement
Two AA size alkaline batteries are needed as the power source. After several hours’ usage of the
batteries, the battery symbol on the screen will be shown as
. The more of dark part indicates the
more close to fill. When the battery capacity runs out, the battery symbol will be shown as
and
will begin to flash. When this occurs, the batteries should be replaced by a new pair.
NOTE:
Pay attention to the polarity of the batteries!
Please take out the batteries when not working during a long period of time.
5.11Connecting to a Computer
The Instrument is equipped with a RS232 serial port. Using the accessory cable (The cable and
following referred software are optional parts), the gauge has the ability to connect to a computer, or
external storage device. Measurement data stored in the memory of the gauge can be transferred to the
computer through the RS232 port. Detailed information of the communication software and its usage
refer to the software manual.
5.12 Error Code Reference
Error Code
Explanation
Error Code
Explanation
E00
Battery exhausted
E05
Can not print
E01
Value out of range
E06
E02
Measurement not finished
E07
E03
Data already saved
E08
E04
No memory data
E09
