Instruction Manual MIT-SCAN-T3
Version 02/2021
Page 35
3.3.5
Measured reflector
On the left hand side of the screen, the selected reflector chosen for
the measurement is displayed. If automatic circular plate recognition
was activated, the reflector which has been identified will be displayed.
This mode will be indicated by an “(A)” next to the name of reflector.
3.3.6
Material quality coefficient
On the right side of display a graphic diagram of material quality
coefficient is shown (s. adjacent Fig. 31).
This provides some useful information for assessing the intactness of
the measuring site, i.e. of the quality of the reflector. The coefficient
has to be within the range of −1.0 to +1.0 to secure a reliable result.
Fig. 31 Display of results
