Mistral EVOPURE, Руководство пользователя

Страница: 9 / 24

9
INSTALLATION
When the water cooler is switched on, both indicator lights on the control panel flash on and off.
Push the sparkling button. The pump engages and fills the carbonator. Wait the carbonator fillng.
WARNING
: ln case of water cutting or low water pressure (water pressure between 2.5 & 3.5 bar), the pump goes into security after
5 minutes 30s to avoid it turns without water.
The drip tray indicator light will be on permanently (without flashing).
You will need to disconnect the power supply of the cooler & reconnect it.
Screw the C02 bottle at back the cooler. Adjust gas pressure between 3 and 3.5 bar.
To adjust gas pressure, turn the regulator, without any tool, clockwise to increase or counterclockwise to lower the pressure.
Then press on « sparkling water » button to adjsut the pressure. Factory settings : 3 bar.
Adjust the mixt C02/water with allen wrench of 4.
The settings is located on the top of the tank.
WARNING : There is a security on sparkling version. This security happens :
• After 5min if one button stays ON continuously during this time
• After 5min 30sec. if the pump works continuously durint this time.
For sparkling version
Unplug and replug the water cooler to reset this default.
Figure 7
Figure 9
Figure 8
When the water cooler is switched on, both indicator lights on the control panel flash on and off.
Press« cold water» button (1) until water dispense.
Then press the hot water red button (2) until water dispenses in order to fill the water-heater.
WARNING : the hot water button has a safety. To dispense water, press on the red « hot water» button, at the same time (2).
Put the switch in position 1 to turn on the resistance of the water heater . The switch is located on the left side of the crossbar.
WARNING : Verify that water heater is filled before to connect it, as damage resistance.
For hot version
Figure 10
1
2
Figure 11