miseno MH00630BS, Руководство пользователя

Страница: 13 / 21

11
1. Measure from range top to desired hood bottom location and
mark line A. (24” minimum from range top) .
2. Plum and mark center line.
3. Mark hood height line B. (11-1/16” from line A)
4. Mark mounting spread from C/L. (12-5/8” on line B)
5. Fasten (2) #6 x 1-1/2” screws into studs on line B but do not
tighten all the way.
Note: Wood blocking may need to be
added behind the drywall if no studs are present. Wall
anchors may also be used but check local codes for
compliance. Failure to use suitable wall anchors to hold
the weight of the hood could result in personal injury or
damage to the cooking surface or counter.
6. Remove (2) screws securing electrical junction box to hood
body. Remove junction box.
7. Remove the (2) filters. Hang hood onto the mounting screws
and hand tighten each screw. (FIG. A #1) Secure third #6 x
1-1/2” screw with washer through inside of hood into wall for
extra support. (FIG. A #2)
8. Center and attach duct cover mounting bracket to wall just
below the ceiling or soffit using (2) #6 x 1” screws. (FIG. A #3)
9. Install duct work and seal with aluminum duct tape*. Re-install
junction box with cable lock and install the electrical. Power up
hood to verify all functions and check for leaks around duct tape
10. Place telescopic duct covers onto hood and extend inner (top)
duct cover upwards and secure to duct cover bracket using (2)
4 x 8mm screws. Re-install filters.
* If using hood in recirculating mode you must secure the air
diverter plate onto wall before installing duct work and duct
covers. Refer to page 14 for more details.
11
1/16
”
Brackets are
pre-installed
24” Min.
A
B
3
1
2
Duct Cover Bracket
12
5/8
”
CAUTION: At least two installers are
required due to the weight and size of the
hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
A cable locking connector (not supplied) might
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
Installation –
Mounting the Hood MH008
FIG. A