Fan does not
move.
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
4. Wires in light kit fitter not wired
correctly.
1. Push switch firmly either up or down.
2. Turn power on or check fuse.
3. Turn power off. Loosen canopy
and check all connections.
4. Check that molex connections in light kit
fitter are connected properly according to
instructions.
Noisy operation.
1. Blades are loose.
2. Cracked blade.
3. Fan is new.
1. Tighten all motor screws/washers.
2. Replace blade.
3. Allow fan a “break in” period of a few
days, especially when running the fan at
Medium and High speeds.
Excessive wobbling.
1. Blades are loose.
2. Unbalanced blades.
3. Fan not securely mounted.
4. Fan too close to vaulted ceiling.
5. Set screw(s) on motor housing yoke
is (are) not tightened properly.
6. Set screw on hanging ball is not
tightened properly.
1. Tighten all motor screws/washers.
2. Switch one blade with a blade from the
opposite side.
3. Turn power off. Carefully loosen canopy
and verify that mounting bracket is secure.
4. Use a longer downrod or move fan
to another location.
5. Tighten yoke set screw(s) securely.
6. Carefully loosen and lower canopy and
verify that set screw on hanging ball is
tightened securely.
Fan operates but
lights fail (if
applicable).
1. Wires in canopy not wired properly.
2. Wall switch to fan is off.
3. Wires from light kit fitter not wired
correctly.
1. Check wires in canopy and, if
necessary, re-wire according to
instructions .
2. Make sure wall switch to fan is on.
3. Check wires on light kit fitter and,
if necessary, re-wire according to
instructions.
©2021 PL Sourcing, Inc. 012021
10
GUÍA DE SOLUCIONES DE PROBLEMAS
Los problemas menores a menudo se pueden solucionar sin un electricista. Antes de comenzar cualquier trabajo, apague la fuente de alimentación para
evitar descargas eléctricas.
El ventilador
no se mueve.
1. El interruptor de reversa no está
activado.
2. No hay alimentación eléctrica
o hay un fusible quemado.
3. La conexión de los cables es
incorrecta.
4. Los cables del soporte del kit de
iluminación no están conectados
correctamente.
1. Mueva firmemente el interruptor
hacia arriba o hacia abajo.
2. Conecte la alimentación eléctrica
o revise el fusible.
3. Desconecte la alimentación. Afloje la
base y revise todas las conexiones.
4. Verifique que las conexiones molex en
el soporte del kit de iluminación estén
bien conectadas de acuerdo con las
instrucciones.
Problema
Causa
Solución