V 20.01
25
English
5.
Additional Settings
5.8
End point filter mode
The end point filter mode is to be used in combination with the miscea end point filter
adapter/accessory. When this mode is enabled, water is dispensed when the water
sector is selected or when a hand is placed under the faucet water outlet. The water
begins to flow and continues to flow even when hands are no longer within the sensor
detection range. To stop the water flow, the water sector must once again be selected
or a hand must once again be placed under the faucet water outlet.
Press the buttons indicated in the following order: «SPOOL» button, «TEMP» button,
«LANG» button. With the «+» and «-» buttons, the end point filter mode can be enabled
and disabled. To save settings, press the «SAVE» button. All colored LED lights illumi-
nate to indicate the new setting has been saved. If the «SAVE» button is not pressed
within 10 seconds of the last selection, the previously saved setting will be stored.
TEMP
LANG
SPOOL
5.7
miscea System Settings for Instantaneous Water Heaters
Please check the software version on the waterbox component. The available settings
are used in combination with instantaneous water heaters when the water pressure
from the hot and cold supply lines are unequal.
Press the buttons indicated in the following order: «DURATION» button, «DEFAULT»
button, «LANG» button. With the «+» and «-» buttons, the cycle through the 3 available
settings. To save settings, press the «SAVE» button. All colored LED lights illuminate to
indicate the new setting has been saved. If the «SAVE» button is not pressed within 10
seconds of the last selection, the previously saved setting will be stored.
SETTING 1: compatible with waterbox software version 0.23
SETTING 2: compatible with waterbox software version 0.24
DEFAULT
LANG
DURATION
Position
1
2
3
4
5
6
7
8
9
Bar position
End Point Filter mode
OFF
ON
CLASSIC (v.1.61+)
Ä
LIGHT (v.1.23+)
Ä
NOTE: For the CLASSIC Pure W Model, the bottom water sector will be deactivated when this function is enabled.
This function is available with faucet software version starting from version number indicated next to each model.
Position
1
2
3
4
5
6
7
8
9
Bar position
Setting
DEFAULT
1
2
CLASSIC (v.1.56+)
Ä
KITCHEN (v.0.41+)
Ä
This function is available with faucet software version starting from version number indicated next to each model.
