Mirpol GRASSE, Руководство по сборке, Страница: 21 / 35

20 PL / EN / CZ GRASSE
EXPLOITATION
Preheating: The user should pour the lava stones completely in order to cover the entire burner before
starting work.
TO TURN ON THE HEARTH
1. Turn the control knob to the „OFF” position.
2. Fully open the LPG cylinder valve.
Note: When starting up for the first time or after each cylinder change, hold the control knob in the
IGNITE position for 10 seconds to purge air from the gas lines before continuing.
3. Push the gas regulator knob in and turn counterclockwise to IGNITE to ignite the fire. If necessary,
press and turn the knob counterclockwise until the heater illuminates (You should hear a click).
4. Release the knob when the firebox ignites. Press and turn the knob to HIGH, then release the
knob. If you want to lower the temperature, push the knob in and turn clockwise to LOW.
Note: If the burner does not ignite, all valves should be closed and wait at least 5 minutes before
attempting to ignite it.
TO TURN OFF THE HEARTH
1. To extinguish the burner, push the knob in and continue turning it clockwise to the OFF position.
2. Turn the cylinder valve clockwise to the OFF position and disconnect the regulator when the
firebox is not in use.
STORAGE, CLEANING AND CARE
• Always close the gas cylinder gas valve after use or in case of malfunction.
• Remove the pressure regulator and hose.
• Check the gas valve for leaks and for damage. If you suspect damage, have it replaced by your gas
dealer.
• Never store LPG cylinders underground or in places without adequate ventilation.
• Wipe the powder coated surfaces with a soft, damp cloth. Do not clean the heater with detergents
flammable or corrosive.
• Remove debris from burner to keep it clean and safe to use.
• Optionally cover the burner with a protective cover when the hearth is not in use.
ROZWIĄZYWANIE PROBLEMÓW
Problem Possible causes Solution
The pressure is low.
The gas cylinder is almost empty. Replace the
cylinder with a full one.
Handwheel locked. Disassemble and clean.
Controls not included. Turn the valve to the ON position.
Faulty thermocouple. Replace thermocouple.
Tilted pilot candle. Place the remote control correctly.
The hearth table is not level. Set it correctly and try again
If the device has any defects or if you have problems with assembly or use, do not try to modify or repair
it yourself. Please contact your vendor or distributor to resolve this issue.