2
R084206, RevB
12. Apply the silicone caulking over the heads of the
screws and around the openings for the fittings when
they are installed.
13. Finish the flanges with drywall or plaster.
TESTING
Test the installation after completing the plumbing, but
before enclosing the base and finishing the surroundings.
Run water for 15 minutes to ensure that there are no leaks
at the drain.
Mirolin Industries Corp. will not be liable for any kind of
damages as a result of not water testing the unit prior to
use by end user.
FINISHING
Apply trim around the shower base periphery to finish
drywall, if required.
Install Shower Door according to the manufacturer’s
instructions if purchased
Mirolin Industries Corp. is not responsible for any
damages incurred as a result of poor installation of the
product.
INSTALLATION CLEAN-UP
Remove construction dirt and residue with a mild liquid
detergent.
DO NOT USE
abrasive cleaners, scouring
compounds and pads, metal scrapers, steel wool, or other
materials that could damage or dull the surface of the bath.
Remove plaster carefully with a blunt wooden block having
rounded edges. Remove paint and other stubborn stains
with isopropyl (rubbing) alcohol.
DO NOT USE
products such as acetone (nail polish
remover), dry cleaning solution, lacquer thinners, gasoline,
pine oil, etc.
MAINTENANCE
The acrylic sheet, which forms the surface of your bathtub,
provides one of the most durable surfaces found in
modern bathrooms. Keep it bright and smooth with mild
liquid household detergent, soap and water, or foaming
cleansers.
NEVER USE
aromatic solvents, abrasive
cleaners, scouring compounds or pads, strong liquid
cleansers, or other material that could damage or dull the
surface of the shower.
Restoring Surface Gloss
- Restore surface gloss by
applying a very fine rubbing compound and polishing the
surface by hand or with a power buffer. Finish with an
application of a good quality automotive wax.
Minor Repairs to Surface
- Remove minor scratches and
scuffs as follows. First, wet sand the area with 600 grit wet
sandpaper until the surface is smooth. Then, restore the
gloss as described under
RESTORING SURFACE
GLOSS
.
FIGURE 2 - FASTENING THE UNIT
Note:
Remove the protective film from the tile flange
before fastening.
8” 203 mm
8” 203 mm
Drill holes about 8’
’ interval
