MIRKA LEROS 950CV, Руководство по эксплуатации, Страница: 64 / 218

• When sanding, always place the tool on the work surface before starting the tool. Always remove the tool from the
work surface before stopping it. This will prevent gouging of the work surface due to excess speed of the abrasive.
• It is strongly recommended that the tool is used in combination with a Mirka Dust Extractor.
Multi-purpose LED indications (see Figure 2)
Meaning Indication
Power connected Multi-purpose LED shows green
Tool switched on. Speed indication active. Multi-purpose LED shows green
Speed indication shows chosen speed. Multi-purpose LED flashes green/red
Over temperature Multi-purpose LED shows red
Voltage out of range Multi-purpose LED quick-flashes green / red
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an App from which additional
tool functionality can be accessed. For more information on the App functionality and if it is available in your country, go
to www.mirka.com.
Activate Bluetooth on your Mirka ® LEROS(-S) as follows:
1. Connect the power cord to mains outlet.
2.
Press and hold the Speed+ button while switching the tool on with the On/Off button.
3. Left LED lights up (green), to indicate that Bluetooth is active.
4.
Bluetooth is deactivated when the tool is disconnected from mains outlet.
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated.
The Bluetooth
®
word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad and interface
Tools required: Hex socket 19 mm, Torx T8 screwdriver and flat head screwdriver.
1.
Remove hole screws (8 pcs).
2. Remove the interface.
3.
Remove the cover cap. Untighten the screw to remove the backing pad.
4. Remove the screw.
5.
Remove the old pad.
6. Attach the new backing pad to the spindle (aligned correctly) and tighten the pad screw with the hex socket.
7.
Attach the cover cap.
8. Fit a new interface.
9.
Refit hole screws (8 pcs).
Replacing the brake seal
NOTE! Too much vacuum in your dust extraction system may cause the brake seal to malfunction.
64
Mirka® LEROS(-S) & 950
en (original)