MIRKA CEROS150NV, Руководство по эксплуатации

Страница: 33 / 110

32
Mirka® CEROS150NV • 32 mm (1 in.) Mirka® CEROS150NV • 32 mm (1 in.)
33
en
Troubleshooting guide
Symptom Possible cause Solution
No light from power supply LED when
switched on.
Power cord not properly attached to power
supply unit or to the mains socket.
Connect it properly.
Faulty fuse. Replace the fuse.
The sander LED is red and the sander
slows down to 4000 RPM when sanding.
Too heavy long term load. Use lighter load. Switch off the power.
Wait 5 seconds. Switch on again.
The sander LED is red and RPM is
slightly reduced.
Temperature too high in the sander. Too
heavy long term load.
Reduce load on the sander for some time
and the sander will speed up again.
The sander LED is red and RPM is
slightly reduced.
Too heavy short term load. Use lighter load and the LED will
automatically change to green.
Technical data
Compact Electrical Random Orbital Sander CEROS150NV
Power 50 W
Mains Voltage 90–240 VAC
DC voltage to sander 22 VDC
Speed 4,000–10,000 rpm
Orbit 5.0 mm
Size of backing pad Ø 32 mm
Weight 587 g
Degree of power supply protection I
Degree of protection of the sander
Noise and vibration information
Measured values are determined according to EN 60745.
Compact Electrical Random Orbital Sander CEROS150NV
Sound pressure level (L
pA
)
47.4 dB(A)
Sound power level (L
WA
)
58 dB(A)
Sound measurement uncertainty K
2 dB
Vibration emission value a
h
1.8 m/s 2
Vibration emission uncertainty K
1.5 m/s 2