Mircom Autodialer ADC Series, Руководство пользователя

Страница: 6 / 24

Entering Programming Mode
2
Entering Programming Mode
Normal Mode
After the system initializes (powers up), the display should appear as shown below.
This is the normal mode of the system. The system will accept all valid codes such as access
codes, keyless entry codes, and the programming master code.
Programming Mode
Before entering programming mode for the first time , restore the factory default master code to
*999 by shorting the reset pins for approximately three seconds. Refer to Figure 22 in the ADC
Instruction and Operation Manual for the location of reset pins. Please be aware that shorting the
reset pins will only restore the factory default master code to *999 and will not affect any
programmed information.
Before programming the system for the first time , clear the system’s memory and restore all
factory defaults by entering*5*5 while you are in the programming menu. Please be aware that
there is no “undo” feature after you have entered *5*5.
To enter programming mode, enter the master code (factory default is ). When you
are in programming mode, the display will read as follows:
This is the programming menu. The system is now waiting for you to enter a valid programming
code. You can program the system either through the programming menu or by using Direct
Access Programming Codes.
Note:
Before programming the system, make sure you have filled out the resident
directory worksheet in the Appendix on page 15.
Please enter the
Resident Code
9 9 9
Enter Code or
<*888> for help