Mirapoint 7700 Series, Руководство по оборудованию

Страница: 28 / 76

Installing Appliance Components
28
2
To install a hot-swap hard drive:
1.
If present, remove the front bezel ( Removing the Front Bezel on page 23).
Figure 11 Installing a Hot-Swap Hard Drive
2. Install the hot-swap hard drive.
a.
Press the button on the front of the drive carrier and open the handle.
b.
Insert the hard-drive module into the drive bay until the module contacts
the backplane.
c. Close the handle to lock the drive in place.
3.
If applicable, install the bezel ( Installing the Front Bezel on page 23).
Optical Drive
An external slimline USB
DVD-ROM
optical drive is provided in the packing box
with your appliance. In the event of a system recovery, this drive is required.
c
Do not lose the external DVD drive. Mirapoint recommends keeping this drive
stored on top of your appliance.
Cooling Fans
Your appliance contains four dual-motor cooling fans. These provide cooling
for the processor, PCI cards, and memory modules. Redundant power supplies also
contain one single-motor fan to provide cooling for the power supplies.
c
Hot-swap removal or installation of the cooling fans is not supported
1 release button 2 hard drive carrier handle
2
1