34
Setting Up the Kaleido-X (7RU) Multi-Viewer
Verifying the Kaleido-RCP2
2
Verifying the Kaleido-RCP2
To verify that the RCP2 is functioning normally:
•
Log on to the RCP2 (see “Using the Kaleido-RCP2 with Default Settings” on page 15), and then test
various operations using the RCP2 keyboard and the mouse (e.g. load a predefined layout).
Verifying the Audio Bridge Terminal
To verify that the ABT is functioning normally:
•
Inspect the ACTIVITY and front panel LEDs on the unit to make sure there are no error conditions:
The ACTIVITY indicator is located on the right-hand side of the rear panel. This LED reports the status
of the Ethernet connection as indicated in the table below.
Two LEDs are visible on the front panel, one for each power supply. When lit, they both indicate the
same status.
When the ABT is powered up, all three LEDs will be orange until the boot sequence is terminated. This
is a visual indicator that the LEDs are functioning properly.
KXA-GPI-GEN - Rear Fan 1 Status
KXA-GPI-GEN - Rear Fan 2 Status
KXA-GPI-GEN - Rear Fan 3 Status
KXA-GPI-GEN - Rear Fan 4 Status
KXA-GPI-GEN - Rear Fan 5 Status
KXA-GPI-GEN - Rear Fan 6 Status
ACTIVITY Indicator on Rear Panel
Power-Supply LEDs on Front Panel
Color
Status
Color
Status
Off
No link detected
Green
Normal
Green
Normal (good link)
Flashing green
Normal, rebooting
Orange
Activity
Orange
Warning
Red
Hardware fault
Flashing orange
Warning, rebooting