Kaleido-X (7RU)
Quick Start Guide
15
Enlarged view of dashboard.
Using the Kaleido-RCP2 with Default Settings
To start using the Kaleido-RCP2 with its default settings:
1. Physically connect the Kaleido-RCP2 unit to the network using an Ethernet cable.
By default, the Kaleido-RCP2 is shipped with DHCP enabled, so it will automatically be assigned an
IP address by a DHCP server. If no DHCP server can be found, the Kaleido-RCP2 will fall back to its
default static IP address, subnet mask, and gateway settings:
2. On the RCP2 unit, press the ENTER button and hold it until the ESC button lights up.
The following message appears on the LCD display:
Configuration
ROOM SELECTION
Default IP address
10.0.3.191
Default subnet mask 255.255.0.0
Default gateway
0.0.0.0
Notes
• If you need to operate with a fixed IP address, you must use the RCP2’s configuration menu to
disable DHCP and set up the correct IP address, Network Mask, and Gateway (see the “Enabling
or Disabling DHCP” and “Setting an IP Address, Subnet Mask and Gateway” sections in the
“Peripheral Equipment” chapter of the Kaleido-X (7RU) Hardware Description & Installation
Manual).
• To access Kaleido-X rooms located in other subnets, the RCP2 must be configured with the
appropriate unicast IP addresses (see the “Configuring Unicast IP Addresses” section in the
“Peripheral Equipment” chapter of the Kaleido-X (7RU) Hardware Description & Installation
Manual).
Application version
Frame IP address
System name
Room name